Produkter & tjänster » Traktionärt » DC/DC
DC Converter for Fork Lift Trucks
Battery driven materials handling equipment normally operate at battery voltages which are greater than 12 V. If additional facilities are required in these vehicles, such as headlamps or flashing beacons components are utilised from the motor vehicle industry. The components are mainly designed for a nominal voltage of 12 V or 24 V. The traction batteries can be used to power extra components, but they have higher voltages e. g. 48 V. If the battery has cells tapped to provide a lower voltage uneven discharging can occur and this will damage the battery. The DC Converters as described below reduces the battery voltage by the use of electronics and can provide a regulated voltage to the load.
The DC Converters described in this list have an output of 250 Watts (18 A), and can be delivered for the following two input voltage ranges:
Range I: 36 V, 48 V, 60 V
Range II: 72 V, 80 V, 96 V
The output voltage is 13,8 V +/- 2% or 27,6 V (+/- 2%)
Input and output are electrically separated and isolated from earth. The output is protected against short circuit. The following LED´s are built in as indicators:
Green LED: Output OK
Yellow LED: Over-temperature
Red LED: Over-voltage cut-out
To provide thermal stability, shock, vibration, security and protection to IP 65 (DIN 40050), the DC Converter is internally provided with a cast heat transfer block.
Further dowload informations:
- DC Converter for Fork Lift Trucks (english) [ 946 KB ]
- DC Converter for Fork Lift Trucks (french) [ 944 KB ]
- DC Converter for Fork Lift Trucks (german) [ 951 KB ]
